How to install the ice maker and how to install the water inlet pipe of the ice maker?

　 An ice maker is a kind of refrigeration mechanical equipment that uses water through an evaporator and is cooled by a refrigeration system refrigerant to produce ice. It uses a refrigeration system and uses water as a carrier to pass through a certain device under power. Out of ice. Many people buy ice machines but don't know how to install them, or install them in the wrong way, and the machine can't run normally. Generally, the installation of the ice machine requires four steps: unpacking, water supply, drainage and start-up. Let's learn about the installation knowledge of the ice maker with the editor.

　　How to install the ice machine

　　1. Unpacking: Open the carton, remove all the packaging, and put the machine On a firm ground, adjust the bottom corner to make it level.

　　2. Water supply: Use one end of the supplied water inlet pipe to tighten the ice machine inlet pipe joint, and one end to connect with the ice making water.

　　3. Drainage: Connect one end of the PVC hose delivered to the ice machine drainage plastic joint and the other end to lead into the sewer. The sewer should be lower than the drain pipe.

　　4. Turn on: plug in the power source, turn the power source under the transom to the 'refrigeration' position, and the machine will enter the fully automatic ice making state.

　　 installation requirements

　　 1. The machine should be placed in a place where the air is unobstructed and far away from the heat source, and the surrounding environment should not Below 10℃, not higher than 40℃.

　　2. When placing, please use the bottom corner bolts to adjust so that the front, back, left and right of the machine are level.

　　 3. The water temperature of the water supply should not be lower than 5℃, not higher than 35℃, water pressure not lower than 138Kpa, not higher than 550Kpa, when there is no water or water shortage Please do not turn it on.

　　4. Please use a drinking water source for ice making water, and install a water filter on the water source to prevent scale formation, filter precipitation, and improve the taste and purity of ice.

　　 5. The power supply is the same as the machine nameplate, the power socket must have a grounding device, and each ice machine is equipped with an independent fuse and circuit breaker.

　　ice maker running program

　　1, turn on : After confirming that the water source and power supply are normal, turn on the water source and turn on the power supply, and the ice maker enters the automatic ice making state.

　　2. Ice harvesting process: The ice maker will first de-icing process when it is turned on for the first time or restarted after shutdown. The compressor and fan motors start to run, and the defrost solenoid valve and water inlet solenoid valve are opened (set time control or temperature control).

　　How to install the water inlet pipe of the ice maker

　　The water inlet and outlet of the cbfi ice machine are generally at the back of the machine and are attached There are related signs, the water inlet pipe is connected to the faucet, and the drain pipe is connected to the drain floor drain. Some machines are equipped with a filter and remember to connect them. Remember to wrap the raw material tape to prevent water leakage. In the case of a split machine, the storage refrigerator also has a drain pipe that also needs to be connected to the floor drain. It is best to follow the instructions carefully.

In an age when cold room supplier is increasingly important, the researchers believe manufacturers should pay close attention to their results.
Providing highly qualified cold room supplier products and services, Guangzhou Icesource Co., Ltd is committed to helping clients make lasting improvements to their performance and realize their most important goals. Over the past decades, we’ve built a firm uniquely equipped to this task. Go to Icesource for more info.
Deeper connections between CBFI and cold room supplierare made when you go beyond the white lights of a corporate space.