How to install the ice maker, how to install the water inlet pipe of the ice maker The ice maker is a kind of refrigeration mechanical equipment that produces ice after water is cooled by the refrigerant of the refrigeration system through the evaporator. After passing through a certain device, ice is produced. Many people buy ice machines but don't know how to install them, or install them in the wrong way, and the machine can't run normally. Generally, the installation of the ice machine requires four steps: unpacking, water supply, drainage and start-up. Let's learn about the installation knowledge of the ice maker with the editor. How to install the ice maker 1. Unpacking: Open the carton, remove all the outer packaging and packaging, put the machine on a firm ground, adjust the bottom corners to make it level. 2. Water supply: Use one end of the supplied water inlet pipe to screw the
Tube Ice Machine inlet pipe joint tightly, and one end to connect with the ice making water. 3. Drainage: Connect one end of the PVC hose that is distributed to the ice maker drainage plastic joint and the other end to lead into the sewer, the sewer should be lower than the drain pipe. 4. Power on: plug in the power source, turn the power source under the transom to the 'refrigeration' position, and the machine will enter the fully automatic ice making state. installation requirements 1. The machine should be placed in a place where the air is unobstructed and far away from the heat source, and the surrounding environment should be no lower than 10°C and no higher than 40°C. 2. When setting up, please use the bottom angle bolts to adjust to make the front, back, left and right of the machine level. 3. The water temperature of the water supply should not be lower than 5℃, not higher than 35℃, and the water pressure should not be lower than 138Kpa and not higher than 550Kpa. Please do not start the machine when there is no water or water. 4. Please use a drinking water source for the ice-making water supply. The water source is equipped with a water filter to prevent scale formation, filter precipitation, and improve the taste and purity of ice. 5. The power supply is consistent with the nameplate of the machine, the power socket must have a grounding device, and each ice machine is equipped with an independent fuse and circuit breaker. Ice maker operation program 1. Turn on: After confirming that the water source and power supply are normal, turn on the water source and power on, and the ice maker enters the automatic ice making state. 2. Ice harvesting process: The ice maker will de-icer first when it is turned on for the first time or restarted after shutdown. The compressor and fan motors start to run, and the defrost solenoid valve and water inlet solenoid valve are opened (set time control or temperature control). How to install the water inlet of the ice machine Remember to connect the filter, and remember to wrap the raw material tape around the connected part to prevent water leakage. In the case of a split machine, the storage refrigerator also has a drain pipe that also needs to be connected to the floor drain. It is best to follow the instructions carefully.
In the present growing world of emerging technology, the has demanding operation in various sectors like ice maker machine, ice maker machine, ice maker machine and many other industries at ice maker machine levels of manufacturing and designing.
Crazy about products? Guangzhou Icesource Co., Ltd is the place you must shop at, do visit Icesource to check out our latest collections!
The risk of ice maker machine is reduced by ice maker machine with the consumption of .
