The fault maintenance of the snow machine is generally caused by the usual illegal operations. As an operator, you must simply deal with some of the faults of the automatic box opener. Here I will share with you how to deal with the common faults of the snow machine. Fault 1: When the machine is in normal use, two or one cylinders do not stir. *, pay attention to the correct ratio of white sugar to water 1:6.5, increase the amount of white sugar appropriately; second, check the operation of the mixing shaft to see if it is operating normally; third, check the bayonet of the mixing blade to see if it Normal, if there is any problem, it should be replaced in time; fourth, check the running status of the geared motor, if there is any problem, it should be replaced in time. Fault 2: One or two of the beverage cylinders are not cooling or the cooling is poor. *, check whether the power supply voltage is within the specified voltage, whether the line is too long, whether the wiring port is loose, if there are any above problems, you should adjust it in time; second, check the wind condition of the machine and the surrounding distance; third, whether there is a condenser If the dust accumulates, clean the dust on the condenser in time; fourth, check the operation of the fan, and replace it in time if there is a problem; fifth, check the status of the refrigeration switch and stirring switch, and replace it in time if there is a problem. Fault 3: The sealing ring of the snow machine barrel leaks. If this happens, you need to check the condition of the barrel sealing ring of the beverage barrel, and replace it in time if there is any problem. Fault 4: Material leakage at the discharge valve port of the snow machine. Firstly, check the condition of the sealing ring. If there is any problem, replace it in time. Apply a proper amount of petroleum jelly when replacing. Secondly, check the condition of the sealing plug. If there is a problem, replace it in time. Apply a proper amount of petroleum jelly when replacing. Fault 5: The top light on the top of the snow maker does not light up. The first is to check the condition of the transformer, if there is a problem, it should be replaced in time; the second is to check the circuit board of the top light to see if there is a problem, and if there is a problem, replace it. The above is an introduction to how to analyze the common faults of the snow machine.
