The specifications and models of the ice machine used in the laboratory are distinguished according to the output. The output of most ice machine manufacturers is calculated according to the room temperature of 10 degrees and the inlet temperature of 10 degrees, but the specific methods are explained in detail below. . The capacity of the ice storage bucket of an
cbfi ice machine is an important indicator for choosing an ice maker. Therefore, operators in laboratories and biological industries are more likely to use it. However, when we select the ice production volume of the ice maker, we need to According to the demand, choose the model that suits you. The ice storage bucket and your own ice demand correspond to each other. If the probability of the relevant laboratory personnel picking ice is relatively low, you can choose a smaller ice storage bucket, and the ice output can choose a smaller model. Note: 1. The ice maker should not be placed in an open air environment. It is best to install it in a safe, clean, well-ventilated environment, and not be exposed to direct sunlight and rain. 2. The
cbfi ice machine should not be close to the heat source, and the operating environment should not be lower than 5°C and no higher than 40°C, so as to avoid excessive temperature affecting the heat dissipation of the condenser and failing to achieve a good ice-making effect. 3. The ice maker should be installed on a stable platform, and the anchor bolts at the bottom of the machine should be adjusted to ensure that the machine is placed horizontally, otherwise it will cause no ice removal and noise during operation. There should be space around, in order to facilitate heat dissipation, the space on the left, right and rear of the machine should not be less than 150mm. 4. The ice maker should use the specified independent power supply that meets the national standards. The power supply should ensure reliable grounding, and be equipped with fuses and leakage protection switches. Voltage fluctuations should not exceed ±10% of the rated voltage. 5. The ice maker should use a water source that meets local drinking water standards and install filters to remove impurities in the water, avoid clogging the water pipe, polluting the water tank and ice mold, and affecting ice making performance. The minimum water temperature is 2℃, the maximum does not exceed 35℃, the minimum water pressure is 0.02Mpa, and the maximum is 0.8Mpa. Our ice machine is often fully automatic during operation, so when the ice storage bucket is slow, the machine will automatically stop by acquiring a signal, so the ice storage bucket determines the capacity of the ice machine to take ice at one time . Related reading: Detailed analysis of the actual operation of the laboratory ice machine
Guangzhou Icesource Co., Ltd shows how effective market design can encourage participation, reduce gaming, and aggregate information, in order to improve liquidity, efficiency, and equity in markets.
We believe our capacity can give you an impressive experience by using
cold room supplier.
cold room supplier is receiving a great positive feedback in the market. And many of our clients are fully satisfied with it.
cold room supplier has its grasp on oversees market also and has a very good repute.
