Five details that cold storage engineers should pay attention to when installing cold storage!

　　The good quality of cold storage determines the return after the cold storage is put into use. Therefore, when choosing a cold storage contractor, the enterprise that uses the storage will carefully review the qualifications of the candidate cold storage contractor, the professionalism of the cold storage plan, and the reasonableness of the cost of the cold storage. The following is a summary of the details of the cold storage installation. I hope it will be of reference significance for you who plan to build a cold storage when evaluating and choosing a cold storage contractor.　　 First, the refrigeration system is the core system of the cold storage, which affects the refrigeration effect of the cold storage, and then affects the storage and preservation effect and economic benefits. Therefore, the refrigeration system should be designed to meet the needs of use and be treated carefully during installation. Under normal circumstances, the condenser and evaporator of the cold storage unit of the refrigeration system are pressure-sealed in the factory, so pay attention to the pressure during opening during the actual installation process, so that on the one hand, you can check whether there is air leakage, on the other hand Always pay attention to the sealing measures of the two copper pipes during the construction process to prevent dust from entering the pipe. The connecting copper pipes of the condenser, the cold storage host, and the evaporator are connected in the form of welding, which makes the interface firm and beautiful.　　Secondly, the copper pipes of the cold storage unit of the cold storage refrigeration system must be separately covered with heat insulation pipes and the wires in the same direction with air conditioning cable ties, and the pipelines should be straight and fixed in sections as much as possible.　　Third, when designing the location of the cold storage unit, try to follow the principle that the closer the evaporator is, the better. This is because such a location makes the cold storage unit good heat dissipation and easy to repair. At the same time, the cold storage unit should not be placed on uneven ground, etc., due to the possible vibration of the cold storage unit during operation, shock-proof gaskets should be placed at the four corners of the cold storage unit during installation and ensure that the level is firm to avoid accidental collisions. fall. Fourth, because the cold storage unit needs to dissipate heat during operation to ensure that the cold storage unit will not overheat and affect performance or stop working, the position of the radiator is designed and installed as close to the cold storage unit as possible. It is best to be higher than the cold storage unit. It should be noted that the air inlet of the radiator should not be facing the air outlet of other equipment or facing other windows (especially residential windows) and equipment. Fifth, most of the cold storage fire accidents that have occurred frequently in recent years are due to short circuits caused by unreasonable design of cold storage wires or aging caused by improperly placed or managed wires. The potential safety hazards of cold storage caused by wire problems can be strengthened during cold storage installation. Preventive measures. If the wires are discharged, all the wires should be protected by corrugated hoses or cable troughs, except that they are tied up with air-conditioning ties. The temperature display wires should not be placed close to the wires as much as possible.